Excelsior JET 7.6 Hotfix 67
Note: This hotfix addresses a regression in Maintenance Pack 5. If you have installed MP5, projects in which the Global Optimizer is enabled may fail to build.
WARNING: Hotfixes address particular problems reported by Excelsior JET users and discovered by Excelsior test engineers between product and Maintenance Pack releases. They are only tested against the core test suite used during development and on the customer scenario(s), if any. We therefore only recommend you to install hotfixes in the following cases:
Excelsior JET 7.6 Maintenance Pack 5 is a prerequisite for this hotfix. If you have not applied MP5, you do not need to apply this hotfix.
Hotfix 67 is also not needed, and therefore not provided, for the Standard Edition.
The most important issues resolved in Excelsior JET 7.6 Hotfix 67 are as follows:
If you are a registered customer of Excelsior JET 7.6, but have not received a user/password combination for Hotfix download, request it from our Support Dept. at email@example.com.
Depending on the platform and Excelsior JET Edition you are using, click one of the download links below:
This hotfix installs on top of Excelsior JET 7.6 with Maintenance Pack 5 applied. If you need to make a fresh installation, install Excelsior JET 7.6 first, cancel JET Setup, apply Maintenance Pack 5, refresh or create profiles as needed, and only then apply this hotfix.
To update an existing Excelsior JET installation, launch the downloaded executable and follow the on-line prompts. Upon successful copying of hotfix files, JET Setup will launch automatically and apply this hotfix.
Installation of this hotfix does not obsolete your current profiles.
To rollback to the previous update level, select Manage JET Updates in Excelsior JET Start Menu and click Undo.
Rollback does not remove the installed updates and associated profiles, so you can reapply thid hotfix later without installing it. Select Manage JET Updates and click Redo until it displays the current configuration as "jet-760-hotfix67".
Run JET Setup to display the list of installed updates:
- jetsetup -show-updates
Locate in the list the updates which you need to activate.
Then run JET Setup again as follows:
- jetsetup -activate-update list
where list is a colon-separated list of update names.
Display the list of profiles available for the new combination of updates:
- If necessary, create new profiles.